Paying an invoice in crypto

Picking a coin, sending the exact amount, and what happens after.

Every invoice is paid in crypto, or from your balance. You choose the coin when you pay, not when you order.

Step by step

  1. Open the invoice under Invoices, or press Pay now where a service shows one.
  2. Pick a coin: Bitcoin, Ethereum, USDT, USDC, Solana or XRP. Only the coins we can take right now are shown. Then press Continue.
  3. The page shows Send exactly, To this address and a QR code. On a phone, Open in wallet fills both in for you.
  4. Send that amount in one payment. If your wallet or exchange takes its fee out of what you send, add the fee on top.
  5. That is all. The page checks by itself, and we check every few minutes as well. One confirmation on the network is enough.

Worth knowing

  • Use the right network. Bitcoin on Bitcoin, ETH on Ethereum, USDT and USDC as ERC20 tokens on Ethereum, SOL on Solana and XRP on the XRP Ledger. A payment sent on another network cannot be seen.
  • XRP needs its destination tag, which the page shows. Without it the payment cannot be matched to you.
  • The amount is held for 6 hours from the moment you pick a coin, at the rate of that moment. If nothing arrives in that time, a first invoice closes and you order again, while a renewal gets a new invoice at once. Coins already seen on the network keep the invoice open.
  • An amount can look a little uneven. When another invoice is open in the same coin, yours is raised slightly so the two payments can be told apart. Send what the page says.
  • Sent too much? One dollar or more over the amount goes to your balance, for the next invoice.

Sent it, and nothing shows?

Give it an hour, since some networks are slow. Then use Sent it, and nothing shows after an hour? on the invoice page. Paste the transaction id, and it reaches us as a ticket so a person can find the payment.

To pay renewals from your balance instead, see Balance, renewals and cancelling.